Home > FAQ & Documents > Software > Alltrax AXE & DCX Software

Alltrax Controller Pro Software

AXE & DCX ControllerPro.exe Build 39 for 2006 and newer
USB Drivers for Win 7 Vista 32 &_64bits  
USB Drivers for Win Vista 32 &_64bits  
USB Drivers for Win 2000 &_XP  
USB Drivers for Win 98  
PDF Controller Programming Interface Drawing  
PDF Controller Pro Instruction Manual  
PDF Technical Note on how to upgrade the Alltrax AXE & DCX Controllers with RS232 Interface  

HPD (ON-OFF)
High Pedal Disable
AXE and DCX Models Only - Prevent motor controller from providing power if throttle is applied prior to Key Switch Turned on
PLUG BRAKE
(ON-OFF)
AXE "P" models ONLY with A2 terminal lug. Provides Plug Braking proportional to throttle position reaching full "Plugging" (Dynamic Motor Braking) when throttle below 25%.
TURBO (ON-OFF) Provides higher speed when not in current limit and throttle is at 100%
1/2 SPEED REVERSE
AXE and DCX Models Only - Limits vehicle speed in reverse based on 50% of forward "Top Speed" setting.

MAX OUTPUT
CURRENT
(0-100%)

50-100% adjustment limits max current supplied to motor.  Used to limit power. (The 400A controller set to 50%=200Amp max)
UNDER-VOLTAGE
Sets the under-voltage where the unit limits power and eventually shuts off and prevents battery damage.
OVER-VOLTAGE
Sets the over-voltage shutoff for the controller during excessive regen or overcharging to prevent damage.
THROTTLE UP RATE
(1-15, Default 4)
Determines the rate of controller output power based on an increasing throttle input.  Setting 1=slow, 15=Fast.
THROTTLE DOWN RATE
(1-15 Default 4)
Determines the rate of controller output power based on a decreasing throttle input. Setting 1=slow, 15=Fast
BRAKE CURRENT
(0-100%)
AXE "P" Models - Adjusts the amount of Plug Brake Current as a percentage of 100A of brake current.
DCX Models - Regeneration Feature is a percentage of possible current available.
TOP SPEED Sets the top speed as a percentage of top-speed

Features :
  • Converts a standard 9-pin serial port to USB
  • Complies with USB Specification v1.1(0) & USB CDC v1.1
  • Full Compliance with USB specification v1.1
  • Supports the RS 232 Serial interface (standard 9-pin serial)
  • Supports automatic handshake mode
  • USB full speed communication and Bus Powered
  • Single Cable USB to Serial communication 
  • Supports up to 1 Mbps data transfer rate
  • Supports Automatic handshake mode
  • 6 Ft. Length
  • Provides a 96 byte buffer for each upstream and downstream data transfer
  • Drivers and Manual on a CD
  • Easy Installation

For PC Users

  • Windows® 95/98/98SE, 2000, ME, XP, Vista & 7
  • Available USB port

Retail Package Content :

  • USB to serial adapter cable
  • Installation & Drivers on CD