Features include:
- For E-Z-Go
DCS / PDS
- Yamaha G19
- Speed and Torque Motor
- Shunt Motor with Regen 36 to 48 VDC
- 8.9 HP Peak @ 5100 rpms *
- 19 Tooth Female Spline (works with the Dana H12 Axle)
- Length 11.25 inches long
- Shipping weight 66 lbs
E-Z-Go DCS & PDS @ 36 VDC
D&D 170-502-0001 |
Recommended Alltrax Controller |
Approx Speed MPH |
Approx % Change in Torque |
| Torque with Stock Tires |
DCX400 |
16-22 |
60 |
| Torque with Stock Tires |
DCX500 |
16-22 |
70 |
| Torque with Stock Tires |
DCX600 |
16-22 |
80 |
| Torque & Speed with Lifted Cart & Large Tires |
DCX400 |
16-22 |
60 |
| Torque & Speed with Lifted Cart & Large Tires |
DCX500 |
16-22 |
70 |
| Torque & Speed with Lifted Cart & Large Tires |
DCX600 |
16-22 |
80 |
Yamaha G10-G22 GMAX @ 48 VDC
D&D 170-502-0001 |
Recommended Alltrax Controller |
Approx Speed MPH |
Approx % Change in Torque |
| **Torque with Stock Tires |
DCX400 |
16-22 |
60 |
| **Torque with Stock Tires |
DCX500 |
16-22 |
70 |
| **Torque with Stock Tires |
DCX600 |
16-22 |
80 |
| **Torque & Speed with Lifted Cart & Large Tires |
DCX400 |
16-22 |
60 |
| **Torque & Speed with Lifted Cart & Large Tires |
DCX500 |
16-22 |
70 |
| **Torque & Speed with Lifted Cart & Large Tires, w/ Turbo Off |
DCX600 |
14 |
80 |
**Beware: This motor will not fit into this golf car without fabrication work or at
least a 3" lift kit being attached. This is because the wheel base on this style
golf car is too narrow and the motor is too long (spring may need to be temp
disconnected).
Vehicle performance specifications are compared to the standard factory performance. Several factors can effect the performance. Some are battery conditions; tire size, tread type and air pressure and varying environmental conditions. Standard factory speeds normally run between 12 - 14 MPH.
It’s recommended that you upgrade wiring throughout the golf cart to a minimum of 4 AWG and a contactor that is rated for 400 amps continuous.
Alltrax has come out with a new set of field maps for the DCX Controllers to maximize the performance of these motors. If you wish to use your current controller it needs to be updated to this new field map or it could cause failure to both the motor & controller. You are welcome to send your controller to us to be programmed for a fee of $15 to pay for shipping the controller back to you.
* (Reference: D&D Motors Specification)
