Features include:
- For E-Z-Go
DCS / PDS
- Yamaha G19
- High Speed Motor
- Stock replacement motor, not intended for lifted carts.
- For Lifted carts please use 170-502-0001
- Shunt Motor with Regen 36 & 48 VDC
- Approximate Speed 18 to 24 mph *
- 20-30% increase in torque
- 8.0 HP Peak
- Replaces XP-2141
- 19 Tooth Female Spline (works with the Dana H12 Axle)
- Length 9.75 inches long
- Actual Weight 49 lbs
- Shipping Weight 51 lbs
EZ-Go DCS & PDS @
36 VDC
170-505-0001 |
Recommended Alltrax Controller |
Approx Speed MPH |
Approx % Change in Torque |
| Speed with Stock Tires |
DCX400 |
18-24 |
20 |
| Speed with Stock Tires |
DCX500 |
18-24 |
30 |
Yamaha G19-G22, GMAX @ 48 VDC
170-505-0001 |
Alltrax Model |
Approx Speed MPH |
Approx % Change in Torque |
| Speed with Stock Tires |
DCX400 |
18-24 |
20 |
| Speed with Stock Tires |
DCX500 |
18-24 |
30 |
Vehicle performance specifications are compared to the standard factory performance. Several factors can effect the performance. Some are battery conditions; tire size, tread type and air pressure and varying environmental conditions. Standard factory speeds normally run between 12 - 14 MPH.
It’s recommended that you upgrade wiring throughout the golf cart to a minimum of 4 AWG and a contactor that is rated for 400 amp continuous.
Alltrax has come out with a new set of field maps for the DCX Controllers to maximize the performance of these motors. If you wish to use your current controller it needs to be updated to this new field map or it could cause failure to both the motor & controller. You are welcome to send your controller to us to be programmed for a fee of $15 to pay for shipping the controller back to you.
* (Reference: D&D Motors Specification)
Warranty:
Warranties are listed on the Policy Page
