This ME0708 is a Brush-Type, Permanent Magnet DC motor with very high efficiency. Capable of 4.8 KW continuous and 15 KW for 1 minute. For voltages from 12 to 48 VDC input and 100 amps continuous (300 amps for 1 minute). Designed to be an Etek-R motor replacement.
| Power |
4.8 KW continuous and 15 KW for 1 minute |
| Voltage |
24-48 Volts |
| Speed |
3360 rpm at 48V Unloaded |
| Size |
8" OD, 5.5" long (w/o shaft) |
| Shaft |
7/8"x 1-5/8", 3/16" key |
| Weight |
30 lbs. |
We recommend that you use an AXE4844 that is turned down to 75% power output. Because the ME0708 has such a low inductance, the controller sees the motor as if it was a short circuit. By having this large controller, it can withstand this low inductance. It is also required to use a contactor that is rated for 200 amp continuous like the MZJ-200D with the appropriate diode & pre-charge resistor.
*Etek is a registered trademark of the Briggs & Stratton Corporation |
