This ME0909 is a Brush-Type, Permanent Magnet DC motor with very high efficiency. Capable of 4.8 KW continuous and 15 KW for 30 seconds. For voltages from 12 to 48 VDC input and 100 amps continuous (300 amps for 30 seconds). Designed for battery operated equipment.
| Power |
4.8 KW continuous 15KW for 30 seconds |
| Voltage |
12 - 48 Volts |
| Speed |
3,984 rpm at 48V Unloaded
83 RPM per Volt |
| Size |
6.88" OD, 6.29" long (w/o shaft) |
| Shaft |
7/8"x 1-5/8", 3/16" key |
| Weight |
24.1 Lbs. |
We recommend that you use an AXE4844 that is turned down to 80% power output. Because the ME00909 has such a low inductance, the controller sees the motor as if it was a short circuit. By having this large controller, it can withstand this low inductance. It is also required to use a contactor that is rated for 200 amp continuous like the MZJ-200D with the appropriate diode & pre-charge resistor.
*Etek is a registered trademark of the Briggs & Stratton Corporation |
